Mytek-digital Protools HD DIO Card (ver. 1.1 / Oct 2010) Manuel d'utilisateur télécharger pdf (Page 5)

Mytek Protools-HD DIO Card – User Manual

Quick Start

1. DIO-HD card installation

Remove the top cover from the converter, unscrew

DIOCARD1 slot plate (first slot from the right while looking

at the rear panel) and install the DIO-HD card using

provided screws. Double check that all the connector pins

match properly with the pins of the connector on the main

converter board.

2. Connecting the card to Protools HD ® system

The Pro Tools card must be connected to the Primary Port of

the DIO-HD card. A maximum of two converters (which can

be of different brands) can be connected to each Protools

card. In the case of more than one converter, the second one

should be daisy chained from the Expansion Port of the first

converter to the Primary Port of the second.

3. Connecting the clock signal

The first converter in the Pro Tools system must operate on

internal clock and is the system clock master. We

recommend always making Mytek the master as it

incorporates a superior clock generator with multiple

wordclock outputs. When a 192 I/O Digidesign interface is

connected in the slave configuration, WCK on the front

panel of Mytek converter must be set to FS/4.

4. Hardware Setup Configuration

Choose Setup > Hardware Setup and check sampling

frequency, clock signal (should be set to Internal) and

confirm Input and Output interfaces are present. Every

converter in the menu should be Set to Default

Remember to turn off

power, and disconnect

power and signal cables

while working with the top

cover removed.

Turn down the amplifier

and speakers connected to

the computer while

launching the Pro Tools

application.

User Manual ver. 1.1 / oct 2010 www.mytekdigital.com Page: 5 / 29

1 2 3 4 5 6 7 8 9 10 ... 28 29

Pas de commentaire

Mytek-digital Protools HD DIO Card (ver. 1.1 / Oct 2010) Manuel d'utilisateur Page 5