Mytek-digital Protools HD DIO Card (ver. 1.1 / Oct 2010) Manuel d'utilisateur télécharger pdf (Page 16)

Mytek Protools-HD DIO Card – User Manual

Output

To playback signal from Protools to the converter's analog

outputs DIOCARD 1 SOURCE TO ANALOG OUT should be

selected. If SOURCE TO DIGITAL OUT is set to DIOCARD1 as

well audio is relayed from the Pro Tools system to the converter

DAC (analog out) and to AES/EBU outputs as well as other

digital outputs if installed.

The actual signal flow in the 8X192ADDA is available in the

form of schematics in the 8X192ADDA manual.

The Protools tracks to be sent to the 8X192 ADDA can be

selected in the ProTools software. In Setup > I/O Setup you can

assign interfaces to signal outputs, later assigned to tracks in the

Pro Tools application.

While track outputs are assigned to channels in the Protools

software, the actual signal routing of the incoming 8 channels to

the converter's physical inputs and outputs must be done

manually on the converter front panel ( SOURCE TO ANALOG

OUT and SOURCE TO DIGITAL OUT). This routing may

initially appear confusing, but after studying the signal flow

diagram in the 8X192ADDA manual you will find it makes a lot

of sense by providing very useful system flexibility.

Editing panel – assigning

output channels

User Manual ver. 1.1 / oct 2010 www.mytekdigital.com Page: 16 / 29

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Pas de commentaire

Mytek-digital Protools HD DIO Card (ver. 1.1 / Oct 2010) Manuel d'utilisateur Page 16